PCV Valve: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL VENTILATION VALVE SUB-ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
  Adhesive:
  
  Toyota genuine adhesive 1324, three bond 1324 or equivalent
  
  Fig 1: Applying Adhesive To Threads Of Ventilation Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 19 mm deep socket wrench, install the ventilation valve sub-assembly.
  Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
  
  Fig 2: Installing Ventilation Valve Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the No. 2 ventilation hose to the ventilation valve sub-assembly.
INSTALL INTAKE MANIFOLD
1. Install the intake manifold (See INSTALLATION ).
INSPECT FOR OIL LEAK

Fig 3: Locating No. 2 Ventilation Hose

G05998672

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002