Section 8 (Engine Cooling System (1AR-FE)): Thermostat: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL THERMOSTAT
1. Install a new gasket to the thermostat.
2. Install the thermostat with the jiggle valve facing upward.
  HINT:
  
  The jiggle valve may be set to within 10° on either side of the prescribed position.
Fig 1: Identifying Jiggle Valve
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WATER INLET
1. Install the water inlet with the 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
CONNECT NO. 2 RADIATOR HOSE (See INSTALLATION )

Fig 2: Locating Nuts And Water Inlet
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL GENERATOR ASSEMBLY (See INSTALLATION )
INSTALL V-RIBBED BELT
HINT:

See INSTALLATION
ADD ENGINE COOLANT (See COOLANT )
INSPECT FOR COOLANT LEAK (See COOLING SYSTEM )
INSTALL NO. 1 ENGINE UNDER COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).