Front Crankshaft Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TIMING CHAIN COVER OIL SEAL
1. Apply MP grease to the lip of a new oil seal.
  NOTE:
  - Do not allow foreign matter to contact the lip of the oil seal.
  - Do not allow MP grease to contact the dust seal.
2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
  SST 09223-22010
  NOTE:
  - Keep the lip of the oil seal free from foreign matter.
  - Do not tap in the oil seal at an angle.
INSTALL CRANKSHAFT PULLEY
1. Align the pulley set key with the key groove of the crankshaft pulley.
  
  Fig 1: Tapping Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, hold the crankshaft pulley and install the pulley bolt.
  SST 09213-54015, 91551 -80650, 09330-00021
  
  Torque: 260 N*m (2651 kgf*cm, 192 ft.*lbf)
INSTALL V-RIBBED BELT (See INSTALLATION )
INSTALL FRONT FENDER APRON SEAL RH (See ENGINE UNIT )
INSTALL FRONT FENDER LINER RH (See INSTALLATION )

Fig 2: Installing Pulley Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH (See CAMSHAFT )
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)