LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation) >> Knock Sensor >> Removal

Knock Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INTAKE MANIFOLD 
    1. Remove the intake manifold (See REMOVAL ).
  2. REMOVE KNOCK SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Bolt And Sensor
      G05997207Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals