LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Exhaust Assembly (1AR-FE)) >> Exhaust Pipe And Catalytic Converter >> Removal

Exhaust Pipe And Catalytic Converter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TAIL EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts and 2 compression springs.
    2. Remove the tail exhaust pipe assembly from the exhaust pipe support.
    3. Remove the gasket from the center exhaust pipe assembly.
    Fig 1: Locating Bolts And Compression Springs
    G06115308Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE EXHAUST PIPE DAMPER 
    1. Remove the exhaust pipe damper from the center exhaust pipe assembly.
    Fig 2: Locating Exhaust Pipe Damper And Center Exhaust Pipe Assembly
    G06115309Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CENTER EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts.
    2. Remove the center exhaust pipe assembly from the 4 exhaust pipe supports.
    3. Remove the gaskets from the front exhaust pipe assembly.
  4. REMOVE OXYGEN SENSOR 
    1. Remove the oxygen sensor (See REMOVAL ).
    Fig 3: Locating Center Exhaust Pipe Assembly And Exhaust Pipe Supports
    G06115310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY 
    1. Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly.
    2. Remove the gasket from the exhaust manifold assembly.
    Fig 4: Locating Bolts, Compression Springs And Front Exhaust Pipe Assembly
    G06115311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals