INTAKE AIR CONTROL VALVE ACTUATOR (for TCV): Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE INTAKE MANIFOLD
1. Remove the intake manifold (See REMOVAL ).
REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)
1. Remove the 2 bolts, intake air control valve actuator and gasket from the intake manifold.
Fig 1: Locating Bolts And Intake Air Control Valve Actuator
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
- Make sure that foreign matter, such as water, oil, sand and iron particles, does not enter the gear chamber or actuator at the locations marked by the circles in the illustration.
  
  Fig 2: Locating Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Do not loosen or remove the bolt and 2 nuts shown in the illustration.
Fig 3: Locating Bolt And Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002