LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Fuel System (1AR-FE)) >> Fuel Pressure Regulator >> Installation

Fuel Pressure Regulator: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY 
    1. Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel pressure regulator.
      Fig 1: Identifying Fuel Pressure Regulator O-Rings
      G06113027Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the fuel pressure regulator to the fuel filter.
  2. INSTALL NO. 1 FUEL SUCTION SUPPORT  (See INSPECTION )
  3. INSTALL FUEL PUMP  (See INSTALLATION )
  4. INSTALL FUEL PUMP HARNESS  (See INSTALLATION )
    Fig 2: Identifying Fuel Pressure Regulator
    G06113028Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL FUEL SENDER GAUGE ASSEMBLY  (See REMOVAL )
  7. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE 
    1. Install fuel suction tube assembly with pump and gauge (See INSTALLATION ).
scientia non olet · About LEMON Manuals