LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Starting System (1AR-FE)) >> Starter >> Removal

Section 10 (Starting System (1AR-FE)): Starter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE BATTERY  (See REMOVAL )
  5. REMOVE NO. 2 INLET AIR CLEANER  (See REMOVAL )
  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE AIR CLEANER BRACKET  (See REMOVAL )
  10. REMOVE NO. 1 INLET AIR CLEANER  (See REMOVAL )
  11. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter connector.
    2. Open the terminal cap, remove the nut and disconnect the starter wire.
      Fig 1: Locating Starter Connector And Starter Wire Terminal Nut
      G06115689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 bolts and starter.
    Fig 2: Locating Starter Bolts
    G06115690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals