FRONT DRIVE SHAFT (for 1AR-FE): Removal

HINT:

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.

1. REMOVE NO. 1 ENGINE UNDER COVER 
2. REMOVE NO. 2 ENGINE UNDER COVER 
3. REMOVE FLOOR UNDER COVER LH 
4. DRAIN AUTOMATIC TRANSAXLE FLUID 

   HINT:

   (See COMPONENTS )

5. REMOVE FRONT WHEELS 
6. REMOVE FRONT AXLE HUB NUT LH 
   1. Using SST and a hammer, release the staked part of the front axle hub nut.

      SST 09930-00010

      NOTE: Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
   2. While applying the brakes, remove the front axle hub nut.
   Fig 1: Releasing Staked Part Of Front Axle Hub Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH  (See REMOVAL )
8. SEPARATE FRONT SPEED SENSOR LH  (See REMOVAL )
9. SEPARATE TIE ROD ASSEMBLY LH  (See REMOVAL )
10. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM LH  (See REMOVAL )
11. SEPARATE FRONT AXLE ASSEMBLY LH  (See REMOVAL )
12. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH 
    1. Using SST, remove the front drive shaft assembly LH.

       SST 09520-01010, 09520-24010 (09520-32040) 

    NOTE:

    • Be careful not to damage the drive shaft dust cover, boot, or oil seal.
    • Be careful not to drop the drive shaft assembly.
    Fig 2: Removing Front Drive Shaft Assembly LH

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
13. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 
    1. Remove the bearing bracket hole snap ring from the drive shaft bearing bracket.
    2. Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
    NOTE: Do not damage the boot or oil seal.
    Fig 3: Locating Bearing Bracket Hole Snap Ring

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
14. SECURE FRONT AXLE HUB SUB-ASSEMBLY LH 
    1. Using SST, secure the front axle hub bearing.

       SST 09608-16042 (09608-02021, 09608-02041) 

    NOTE: The hub bearing may be damaged if it is subjected to the vehicle's full weight, such as when moving the vehicle with the drive shaft removed. If it is necessary to place the vehicle's weight on the hub bearing, first support it with SST.
    Fig 4: Securing Front Axle Hub Bearing

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002