(Door / Hatch) (Except Hybrid): Hood: Adjustment

HINT:

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart (See SERVICE SPECIFICATIONS - STANDARD BOLT ).

Fig 1: Identifying Centering Bolt And Standard Bolt

G05422058

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE RADIATOR GRILLE (See REMOVAL )
ADJUST HOOD SUB-ASSEMBLY
1. Horizontally and vertically adjust the hood.
  1. Loosen the 4 hinge bolts of the hood.
  2. Adjust the clearance between the hood and front fender by moving the hood.
  3. Tighten the 4 hinge bolts after the adjustment.
    Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
    
    Fig 2: Adjusting Hood Horizontally And Vertically
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Adjust the height of the front end of the hood using the cushion rubber.
  1. Adjust the cushion rubbers so that the heights of the hood and fender are aligned.
    HINT:
    
    Raise or lower the front end of the hood by turning the cushion rubber.
    
    Fig 3: Adjusting Height Of Front End Of Hood
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Adjust the hood lock.
  1. Remove the hood lock nut cap.
    
    Fig 4: Identifying Hood Lock Nut Cap
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Loosen the 3 bolts.
  3. Tighten the bolts after the adjustment.
    Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
    
    Fig 5: Loosening Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the hood lock nut cap.
5. Check that the striker can engage with the hood lock smoothly.
INSTALL RADIATOR GRILLE (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )

Fig 6: Identifying Hood Lock Nut Cap

G05422061

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002