LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer (Except Hybrid) >> CERTIFICATION ECU (w/ Smart Key System) >> Removal

CERTIFICATION ECU (w/ Smart Key System): Removal

  1. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH  (See REMOVAL )
  3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) 
    1. Disconnect the connectors.
    2. Remove the 2 nuts and the certification ECU (smart key ECU assembly).
      Fig 1: Locating Certification ECU Connectors
      G05419666Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals