TIRE PRESSURE WARNING RECEIVER (w/ Antenna): Installation

INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
1. Connect the connector.
  
  Fig 1: Locating Tire Pressure Warning Receiver Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the tire pressure warning receiver assembly with the bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL ROOF HEADLINING ASSEMBLY
HINT:

Refer to the instructions for INSTALLATION of the roof headlining (See INSTALLATION ).

Fig 2: Identifying Tire Pressure Warning Receiver Assembly With Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

See TEST MODE PROCEDURE .