LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Horns >> Horn (Except Hybrid) >> Spiral Cable >> Installation

Spiral Cable: Installation

  1. INSTALL SPIRAL CABLE 
    1. Engage the 6 claws and 2 pins, and install the spiral cable to the steering angle sensor.
  2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR  (See INSTALLATION )
  3. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
    Fig 1: Identifying Steering Angle Sensor Claws And Pins
    G05419253Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. ADJUST SPIRAL CABLE  (See INSTALLATION )
  5. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  6. INSTALL STEERING PAD  (See INSTALLATION )
  7. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  8. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  10. INSPECT STEERING PAD  (See INSTALLATION )
  11. INSPECT STEERING WHEEL CENTER POINT 
  12. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals