LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Except Hybrid) >> Meter/Gauge System >> Entire Combination Meter does not Operate >> Inspection Procedure

Inspection Procedure

  1. INSPECT COMBINATION METER ASSEMBLY 
    1. Disconnect the E1 connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      E1-20 (ES) - Body ground Always Below 1 Ω
      E1-40 (E2) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      E1-1 (IG+) - Body ground Ignition switch on (IG) 10 to 14 V
      E1-21 (B) - Body ground Always 10 to 14 V
      E1-22 (B2) - Body ground Always 10 to 14 V
      Fig 1: Identifying Combination Meter Assembly And E1 Connector Terminals
      G05420384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL  )

scientia non olet · About LEMON Manuals