Combination Meter: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the terminal to prevent airbag deployment (See AIRBAG SYSTEM ).

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
1. Disengage the 4 claws and 4 clips, and remove the instrument cluster finish panel assembly.
  
  Fig 1: Identifying Instrument Cluster Finish Panel Assembly With Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
2. Disconnect the connector and remove the combination meter assembly.
  
  Fig 2: Locating Screws And Combination Meter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002