CLUTCH UNIT (for C59): Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE MANUAL TRANSAXLE ASSEMBLY
See REMOVAL .
REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
1. Remove the clutch release fork with the clutch release bearing from the manual transaxle.
  
  Fig 1: Removing Clutch Release Fork Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH RELEASE FORK BOOT
1. Remove the clutch release fork boot from the manual transaxle.
  
  Fig 2: Identifying Clutch Release Fork Boot
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH RELEASE BEARING ASSEMBLY
1. Remove the release bearing and clip from the clutch release fork.
  
  Fig 3: Identifying Release Bearing And Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RELEASE FORK SUPPORT
1. Remove the release fork support from the manual transaxle.
  
  Fig 4: Identifying Release Fork Support
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH COVER ASSEMBLY
1. Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.
2. Loosen each set bolt one turn at a time until the spring tension is released.
3. Remove the set bolts and pull off the clutch cover.
  NOTE: Do not drop the clutch disc.
  
  Fig 5: Identifying Matchmarks On Clutch Cover Assembly And Flywheel Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH DISC ASSEMBLY
NOTE: Keep the parts clutch disc lining, the pressure plate, and the surface of the flywheel sub-assembly free of oil and foreign matter.