Manual Transaxle Assembly: Installation

1. Install the rear engine mounting bracket with the 3 bolts.

   Torque: 45 N*m (459 kgf*cm, 33 ft.*lbf) 

   Fig 1: Locating Rear Engine Mounting Bracket And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front engine mounting bracket with the 3 bolts.

   Torque: 64 N*m (653 kgf*cm, 47 ft.*lbf) 

   Fig 2: Locating Front Engine Mounting Bracket And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Temporarily install the engine mounting bracket LH with the 4 bolts.
2. Tighten the 4 bolts.

   Torque: 52 N*m (531 kgf*cm, 38 ft.*lbf) 

   Fig 3: Locating Engine Mounting Bracket LH And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the control cable bracket with the 2 bolts.

   Torque: 25 N*m (250 kgf*cm, 18 ft.*lbf) 

   Fig 4: Locating Control Cable Bracket Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Align the input shaft with the clutch disc and install the manual transaxle onto the engine.
2. Install the 7 bolts.

   Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) 

   Fig 5: Locating Manual Transaxle Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   • Insert dowel pins into the dowel holes securely so that the end face of the transaxle assembly fits close against the engine assembly before tightening the bolts.
   • Make sure that the dowel pins are not loose, bent, damaged or scratched and then install the transaxle onto the engine with the contact surfaces of the engine and transaxle flat against each other.

HINT:

See the steps from "Install Engine Assembly With Transaxle" through "Check ABS Speed Sensor Signal" (See INSTALLATION ).