Starting System (2ZR-FE): Starter: Installation

INSTALL STARTER ASSEMBLY
1. Install the starter assembly with the 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
2. Connect the connector.
3. Connect terminal 30 with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
4. Close the terminal cap.
Fig 1: Locating Starter Assembly And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transaxle)
HINT:

See INSTALLATION .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
HINT:

See INSTALLATION .