Exhaust Manifold: Removal

REMOVE FRONT WIPER ARM HEAD CAP (See ON-VEHICLE INSPECTION )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See ON-VEHICLE INSPECTION )
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See REMOVAL )
REMOVE HOOD TO COWL TOP SEAL (See REMOVAL )
REMOVE CENTER NO. 1 COWL TOP VENTILATOR LOUVER (See REMOVAL )
REMOVE COWL TOP VENTILATOR LOUVER LH (See REMOVAL )
REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See REMOVAL )
REMOVE OUTER COWL TOP PANEL (for TMC Made) (See REMOVAL )
REMOVE OUTER COWL TOP PANEL (except TMC Made) (See REMOVAL )
REMOVE NO. 2 CYLINDER HEAD COVER (See REMOVAL )
REMOVE AIR FUEL RATIO SENSOR (See INSPECTION )
REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator.
  
  Fig 1: Locating Bolts And No. 1 Exhaust Manifold Heat Insulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT EXHAUST PIPE ASSEMBLY
1. Disconnect the heated oxygen sensor connector.
2. Remove the 4 bolts and 4 compression springs.
3. Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.
  
  Fig 2: Locating Bolts And Compression Springs
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MANIFOLD STAY
1. Remove the 3 bolts and manifold stay.
  
  Fig 3: Locating Bolts And Manifold Stay
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE EXHAUST MANIFOLD
1. Remove the 5 nuts and exhaust manifold.
2. Remove the exhaust manifold gasket.
  
  Fig 4: Locating Nuts And Exhaust Manifold
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator.
  
  Fig 5: Locating Bolts And No. 2 Exhaust Manifold Heat Insulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002