Inspection Procedure

1. Disconnect the transmission wire connector from the transaxle.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   4 (SLU+) - 9 (SLU-)	20°C (68°F)	5.0 to 5.6 Ω

3. Measure the resistance according to the value(s) in the table below.

Standard resistance (Check for short) 

Fig 1: Identifying B90 Transmission Wire Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: Go to step  3

OK: Go to next step 

1. Connect the transmission wire connector to the transaxle.
2. Disconnect the ECM connectors.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   B31-57 (SLU+) - B31-77 (SLU-)	20°C (68°F)	5.0 to 5.6 Ω

4. Measure the resistance according to the value(s) in the table below.

Fig 2: Identifying B31 ECM Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance (Check for short) 

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE ECM (for 2ZR-FE)  (See REMOVAL )

1. Remove the shift solenoid valve SLU.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   1-2	20°C (68°F)	5.0 to 5.6 Ω

3. Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.

   OK: 

   The solenoid makes an operating sound. 

   NG: REPLACE SHIFT SOLENOID VALVE SLU  (See DISASSEMBLY )

   Fig 3: Inspecting Shift Solenoid Valve SLU

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: REPAIR OR REPLACE TRANSMISSION WIRE  (See REMOVAL )