Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK OTHER DTCS OUT PUT (IN ADDITION TO DTC P2714)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and the Techstream main switch on.
- When you use Techstream:
Select the item "Powertrain / Engine and ECT / Trouble Codes".
- Read the DTCs using the Techstream.
Result
RESULT CHARTResult Proceed to P2714 A P2714 and other DTCs B HINT:
If any other codes besides "P2714" are output, perform the troubleshooting for those DTCs first.
B: Go to DTC CHART (See DIAGNOSTIC TROUBLE CODE CHART )
A: Go to next step
- INSPECT SHIFT SOLENOID VALVE SLT
- Remove the shift solenoid valve SLT.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Condition Specified Condition 1-2 20°C (68°F) 5.0 to 5.6 Ω - Connect the positive (+) lead with a 21 W bulb to terminal 2 and negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
OK:
The solenoid makes an operating sound.
NG: REPLACE SHIFT SOLENOID VALVE SLT (See DISASSEMBLY )
OK: Go to next step
- INSPECT TRANSMISSION VALVE BODY ASSEMBLY
OK:
There are no foreign objects on each valve.
NG: REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLY (See REMOVAL )
OK: Go to next step
- INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY
OK:
The torque converter clutch operates normally.
NG: REPLACE TORQUE CONVERTER CLUTCH ASSEMBLY (See REMOVAL )
OK: REPAIR OR REPLACE AUTOMATIC TRANSAXLE ASSEMBLY (See REMOVAL )