Differential Oil Seal: Replacement

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
REMOVE ENGINE UNDER COVER RH
DRAIN AUTOMATIC TRANSAXLE FLUID (See REMOVAL )
REMOVE FRONT DRIVE SHAFT ASSEMBLY
(See REMOVAL )
REMOVE TRANSAXLE HOUSING OIL SEAL
1. Using SST, pull out the oil seal.
  SST 09308-00010
  
  Fig 1: Removing Transaxle Housing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
1. Using SST, pull out the oil seal.
  SST 09308-00010
  
  Fig 2: Removing Differential Side Bearing Retainer Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE HOUSING OIL SEAL
1. Using SST and a hammer, install a new oil seal.
  SST 09316-60011 (09316-00011)
  
  Oil seal installation depth:
  
  -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
2. Coat the lip of the oil seal with MP grease.
  
  Fig 3: Installing Transaxle Housing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
1. Using SST and a hammer, install a new oil seal.
  SST 09649-17010, 09950-70010 (09951-07150)
  
  Oil seal installation depth:
  
  -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
2. Coat the lip of the oil seal with MP grease.
INSTALL FRONT DRIVE SHAFT ASSEMBLY
(See INSTALLATION )

Fig 4: Identifying Front Drive Shaft Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH