LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla S, 1.8 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - U250E) >> Transmission Wire >> Removal

Transmission Wire: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. DRAIN AUTOMATIC TRANSAXLE FLUID 
    1. Remove the drain plug and gasket to drain the ATF.
    2. Install a new gasket and the drain plug.

      Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

  3. REMOVE BATTERY  (See REMOVAL )
  4. REMOVE BATTERY CARRIER  (See REMOVAL )
  5. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE ENGINE UNDER COVER LH 
  7. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY 
    1. Remove the 18 bolts, oil pan and gasket.
      NOTE: Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.
      Fig 1: Locating Bolts And Oil Pan Gasket
      G04975941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 magnets from the oil pan.
      Fig 2: Identifying Magnets From Oil Pan
      G06011439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Examine particles in the pan.
      1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

        Result: 

        Steel (magnetic): bearing, gear and plate wear 

        Brass (non-magnetic): bushing wear 

        Fig 3: [Removing Magnets]
        G04975943Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DISCONNECT TRANSMISSION WIRE 
    1. Disconnect the 7 shift solenoid valve connectors.
    2. Remove the bolt and lock plate to disconnect the ATF temperature sensor.
      Fig 4: Locating Shift Solenoid Valve Connectors
      G04975944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE TRANSMISSION WIRE 
    1. Disconnect the transmission wire connector.
    2. Remove the bolt and transmission wire.
      Fig 5: Locating Transmission Wire And Bolt
      G04975945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the O-ring from the transmission wire.
      Fig 6: Locating O-Ring From Transmission Wire
      G04975946Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002