Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (SR)
- Disconnect the transmission wire connector from the transaxle.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 9 - Body ground 20°C (68°F) 11 to 15 Ω NG: Go to step 3
OK: Go to next step
- CHECK HARNESS AND CONNECTOR (TRANSMISSION - ECM)
- Connect the transmission connector to the transaxle.
- Disconnect the connector from the ECM.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Specified Condition Specified Condition B31-80 (SR) - Body ground 20°C (68°F) 11 to 15 Ω NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE ECM (See REMOVAL )
- INSPECT SHIFT SOLENOID VALVE SR
- Remove the shift solenoid valve SR.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition Solenoid Connector (SR) - Solenoid Body (SR) 20°C (68°F) 11 to 15 Ω - Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
OK: The solenoid makes an operating sound.
NG: REPLACE SHIFT SOLENOID VALVE SR (See DISASSEMBLY )
OK: REPAIR OR REPLACE TRANSMISSION WIRE (See REMOVAL )