Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (S4)
- Disconnect the transmission wire connector from the transaxle.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 3 - Body ground 20°C (68°F) 11 to 15 Ω NG: Go to step 3
OK: Go to next step
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
- Connect the transmission connector to the transaxle.
- Disconnect the connector from the ECM.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition B31-78 (S4) - Body ground 20°C (68°F) 11 to 15 Ω NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE ECM (See FAIL-SAFE CHART )
- INSPECT SHIFT SOLENOID VALVE S4
- Remove the shift solenoid valve S4.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition Solenoid Connector (S4) - Solenoid Body (S4) 20°C (68°F) 11 to 15 Ω - Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
OK: The solenoid makes an operating sound.
NG: REPLACE SHIFT SOLENOID VALVE S4 (See DISASSEMBLY )
OK: REPAIR OR REPLACE TRANSMISSION WIRE (See REMOVAL )