Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE (SL1)
- Disconnect the transmission wire connector from the transaxle.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 6 (SL1+) - 13 (SL1-) 20°C (68°F) 5.0 to 5.6 Ω - Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for short)
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 6 (SL1+) - Body ground Always 10 kΩ or higher 13 (SL1-) - Body ground Always NG: Go to step 3
OK: Go to next step
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
- Connect the transmission connector to the transaxle.
- Disconnect the connector from the ECM.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition B31-57 (SL1+) - B31-77 (SL1-) 20°C (68°F) 5.0 to 5.6 Ω - Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for short)
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition B31-57 (SL1+) - Body ground Always 10 kΩ or higher B31-77 (SL1-) - Body ground Always NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE ECM (See FAIL-SAFE CHART )
- INSPECT SHIFT SOLENOID VALVE SL1
- Remove the shift solenoid valve SL1.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 1 - 2 20°C (68°F) 5.0 to 5.6 Ω - Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
OK: The solenoid makes an operating sound.
NG: REPLACE SHIFT SOLENOID VALVE SL1 (See DISASSEMBLY )
OK: REPAIR OR REPLACE TRANSMISSION WIRE (See REMOVAL )