LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Clutches Manual & Hydraulic (Except Hybrid)) >> Clutch Release Cylinder >> Installation

Clutch Release Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY 
    1. Install the clutch release cylinder and clutch line bracket with the 2 bolts.

      Torque: 12 N*m (120 kgf*cm, 9 ft.*lbf) 

      Fig 1: Locating Clutch Release Cylinder Bolts
      G04977136Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CLUTCH ACCUMULATOR ASSEMBLY  (See INSTALLATION )
  3. CONNECT CLUTCH LINE  (See INSTALLATION )
  4. INSTALL RELEASE CYLINDER HEAT INSULATOR  (See INSTALLATION )
  5. INSTALL CLUTCH ACCUMULATOR BRACKET  (See INSTALLATION )
  6. BLEED CLUTCH LINE 
    1. Fill the brake reservoir with brake fluid and bleed the clutch system.

      Torque: 8.3 N*m (85 kgf*cm, 74 in.*lbf) 

  7. CHECK FOR BRAKE FLUID LEAKAGE 

    HINT:

    Check for leakage in the clutch system.

  8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  10. INSTALL AIR CLEANER INLET ASSEMBLY  (See INSTALLATION )
  11. CHECK FLUID LEVEL IN RESERVOIR 
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
scientia non olet · About LEMON Manuals