Engine Rear Oil Seal: Installation

INSTALL ENGINE REAR OIL SEAL
1. Apply MP grease to a new oil seal lip.
  NOTE: Keep the lip free from foreign matter.
2. Using SST and a hammer tap in the oil seal until its Surface is flush with the rear oil seal retainer edge.
  SST 09223-15030, 09950-70010 (09951 -07100)
  
  NOTE: Wipe off extra grease from the crankshaft.
  
  Fig 1: Installing Engine Rear Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)
1. TMMK made:
  1. Using SST, hold the crankshaft.
    SST 09960-10010 ({19962411000, 09963-01000)
    
    Fig 2: Holding Crankshaft (TMMK)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. TMC made:
  1. Using SST, hold the crankshaft.
    SST 09213-54015 (91651 -60855), 09330-00021
    
    Fig 3: Holding Crankshaft (TMC)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Clean the bolt and the bolt hole.
4. Apply adhesive to 2 or 3 threads of the bolt end.
  Adhesive:
  
  Part No. 08833-00070, THREE BOND or equivalent
5. Install the flywheel with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.
  Torque: 130 N*m (1,330 kgf*cm, 96 ft.*lbf)
  
  Fig 4: Tightening Flywheel Bolts In Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle) (See REASSEMBLY )
INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle) (See REASSEMBLY )
INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)
1. TMMK made:
  1. Using SST, hold the crankshaft.
    SST 09960-10010 (09962-01000, 09963-01000)
    
    Fig 5: Holding Crankshaft (TMMK)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. TMC made:
  1. Using SST, hold the crankshaft.
    SST 09213-54015 (91651 -60855), 09330-00021
    
    Fig 6: Holding Crankshaft (TMC)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Clean the bolt and the bolt hole.
4. Apply adhesive to 2 or 3 threads of the bolt end.
  Adhesive:
  
  Part No. 08833-00070, THREE BOND or equivalent
5. Install the front spacer, drive plate and rear spacer with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.
  Torque: 98 N*m (1,000 kgf*cm, 72 ft.*lbf)
  
  Fig 7: Tightening Drive Plate And REar Spacer Bolts In Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
HINT:

See INSTALLATION .
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)
HINT:

See INSTALLATION .