Charging System (2AZ-FE) (Except Hybrid): Generator: Installation

INSTALL GENERATOR ASSEMBLY
1. Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
  
  Fig 1: Identifying Wire Harness Is Secured to Wire Harness Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the generator assembly with the 2 bolts.
  Torque:
  
  Bolt A 21 N*m (215 kgf*cm, 16 ft.*lbf)
  
  Bolt B 52 N*m (530 kgf*cm, 38 ft.*lbf)
  
  Fig 2: Locating Generator Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the generator wire to terminal B with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 3: Identifying Generator Wire To Terminal B Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the clamp bracket with the bolt.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
5. Attach the clamp and connect the generator connector to the generator.
INSTALL V-RIBBED BELT (See INSTALLATION )
INSTALL FRONT FENDER APRON SEAL RH
INSTALL ENGINE UNDER COVER RH
INSTALL FRONT WHEEL RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )