Drive Belt: Installation

1. Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the V-ribbed belt.

   SST 09216-42010 

   NOTE:

   • Be sure to connect SST and the tools so that they are in line during use.
   • When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
   • After the tensioner is fully retracted, do not apply force any more than necessary.
2. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Check to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.
   Fig 1: Installing V-Ribbed Belt With Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)