LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical (Except Hybrid) >> Brake Pedal >> Removal

Brake Pedal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH  (See REMOVAL )
  5. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System)  (See REMOVAL )
  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System)  (See REMOVAL )
  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL  (See REMOVAL )
  9. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  10. REMOVE BRAKE BOOSTER ASSEMBLY 

    HINT:

    Refer to the procedures up to "REMOVE BRAKE BOOSTER". (See REMOVAL )

  11. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY 
    1. Disconnect the stop light switch connector and disengage the 2 clamps.
      Fig 1: Locating Stop Light Switch Connector
      G04978310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove 2 bolts (A), bolt (B) and the No. 1 brake pedal support plate.
      Fig 2: Locating No. 1 Brake Pedal Support Plate Bolts
      G04978311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and the brake pedal support assembly.
      Fig 3: Locating Brake Pedal Support Assembly Bolt
      G04978312Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals