Brake Booster: Removal

1. Remove the brake pedal return spring.
   Fig 1: Locating Brake Pedal Return Spring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the clip and the push rod pin, and separate the master cylinder push rod clevis.

1. Slide the clip and disconnect the No. 2 vacuum hose.
   Fig 2: Locating No. 2 Vacuum Hose Clip

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Refer to the procedures up to "REMOVE MASTER CYLINDER". (See REMOVAL )

1. Remove the 4 nuts and the brake booster assembly.

Fig 3: Locating Brake Booster Assembly Nuts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the brake booster gasket.
   Fig 4: Locating Brake Booster Gasket

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Loosen the lock nut and remove the brake master cylinder push rod clevis.