Brake Pedal: Installation

1. Temporarily install the brake pedal support assembly with the bolt.
   NOTE: Fully tighten the bolt after installing the brake booster assembly.
   Fig 1: Locating Brake Pedal Support Assembly Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the No. 1 brake pedal support plate with 2 bolts (A) and bolt (B).
   NOTE: Fully tighten 2 bolts (A) and bolt (B) after installing the brake booster assembly.
   Fig 2: Locating No. 1 Brake Pedal Support Plate Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Temporarily install the brake booster assembly and the gasket with the 4 nuts.
   Fig 3: Locating Brake Booster Assembly Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Fully tighten the bolt.

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

   Fig 4: Locating Brake Pedal Support Assembly Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Fully tighten 2 bolts (A) and bolt (B).
   Fig 5: Locating No. 1 Brake Pedal Support Plate Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 

   Bolt (A) 

   19 N*m (194 kgf*cm, 14 ft.*lbf) 

   Bolt (B) 

   13 N*m (133 kgf*cm, 10 ft.*lbf) 

6. Engage the 2 clamps and connect the stop light switch connector.
   Fig 6: Locating Stop Light Switch Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Refer to the procedures up to "INSTALL BRAKE BOOSTER ASSEMBLY". (See INSTALLATION )