Luggage Compartment Door: Adjustment

HINT:

• Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
• A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).
  Fig 1: Identifying Centering Bolt And Standard Bolt

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. REMOVE LUGGAGE COMPARTMENT DOOR COVER  (See REMOVAL )
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
3. REMOVE SPARE WHEEL COVER CLAMP 
4. REMOVE SPARE WHEEL COVER ASSEMBLY 
5. REMOVE LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY  (See REMOVAL )
6. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK  (See REMOVAL )
7. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
8. ADJUST LUGGAGE COMPARTMENT DOOR 
   1. Loosen the door side hinge bolts to adjust the door horizontally and vertically.

      Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) 

      Fig 2: Adjusting Luggage Compartment Door Hinge Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic hammer.
      Fig 3: Adjusting Striker Position

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Tighten the striker mounting screws after the adjustment.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

9. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
10. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK  (See INSTALLATION )
11. INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY  (See INSTALLATION )
12. INSTALL SPARE WHEEL COVER ASSEMBLY 
13. INSTALL SPARE WHEEL COVER CLAMP 
14. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
15. INSTALL LUGGAGE COMPARTMENT DOOR COVER  (See INSTALLATION )