LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Avalon XLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Seat Belt) >> Rear Seat Outer Belt Assembly >> Removal

Rear Seat Outer Belt Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    HINT:

    See PRECAUTION

  2. REMOVE REAR SEAT CUSHION ASSEMBLY  (See REMOVAL )
  3. REMOVE REAR SEAT HEADREST ASSEMBLY 
  4. REMOVE REAR SHELF COVER CAP  (See REMOVAL )
  5. REMOVE REAR SEATBACK ASSEMBLY LH  (See REMOVAL )
  6. REMOVE REAR SEATBACK ASSEMBLY RH  (See REMOVAL )
  7. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL )
  8. REMOVE REAR DOOR SCUFF PLATE RH  (See REMOVAL )
  9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 
  10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH 
  11. REMOVE REAR SEAT SIDE GARNISH LH  (See REMOVAL )
  12. REMOVE REAR SEAT SIDE GARNISH RH  (See REMOVAL )
  13. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER LH  (See REMOVAL )
  14. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER RH  (See REMOVAL )
  15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Remove the bolt and disconnect the rear seat belt assembly outer.

      HINT:

      Use the same procedures for the RH side and LH side.

      Fig 1: Identifying Rear Seat Belt Assembly Outer Bolt
      G05005390Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and disconnect the rear seat inner w/ center belt assembly RH.
      Fig 2: Identifying Rear Seat Inner W/ Center Belt Nut
      G05005391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 4 claws and the rear seat shoulder belt cover.

      HINT:

      Use the same procedures for the RH side and LH side.

      Fig 3: Identifying Rear Seat Shoulder Belt Cover Claws
      G05005392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 4 claws and the rear seat shoulder belt cover.
      Fig 4: Identifying Rear Seat Shoulder Belt Cover Claws
      G05005393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the 5claws, 4clips, and the package tray panel assembly.
    6. Disconnect the connector and remove the package tray panel assembly.
      Fig 5: Identifying Package Tray Panel Assembly Claws And Clips
      G05005394Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE REAR SEAT BELT ASSEMBLY OUTER 
    1. Remove the bolt and the rear seat belt assembly outer.
scientia non olet · About LEMON Manuals