Rear Seat Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Only installation procedures requiring additional information are included.

REMOVE REAR SEAT CUSHION ASSEMBLY
1. Pull up the 2 portions of the rear seat cushion assembly as shown in the illustration and remove it.
  A: 100 mm (3.94 in.) or less
  
  NOTE: In this case, hold the base of the clip up to prevent the cushion frame from being distorted.
2. Disconnect each wire of the reclining adjuster arm sub-assembly RH and remove the rear seat cushion assembly.
REMOVE REAR SEAT HEADREST ASSEMBLY
REMOVE REAR SEATBACK LOCK COVER CAP
1. Disengage the 6 claws and remove the 2 RR shelf cover caps.
  
  Fig 1: Identifying Claws For RR Shelf Cover Caps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Fig 2: Removing RR Shelf Cover Caps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEATBACK ASSEMBLY LH
1. Remove the rear seat belt from the rear seat shoulder belt guide LH.
  
  Fig 3: Removing Rear Seat Belt From Rear Seat Shoulder Belt Guide LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt, 2 nuts and the rear seatback assembly LH.
  
  Fig 4: Removing Bolt, Nuts And Rear Seatback Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEATBACK ASSEMBLY RH
1. Remove the rear seat belt from the rear seat shoulder belt guide RH.
  
  Fig 5: Removing Rear Seat Belt From Rear Seat Shoulder Belt Guide RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the rear seat belt from the rear seat shoulder belt guide center.
  
  Fig 6: Removing Rear Seat Belt From Rear Seat Shoulder Belt Guide Center
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the bolt, 2 nuts and the rear seatback assembly RH.
  
  Fig 7: Removing Bolt, Nuts And Rear Seatback Assembly RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002