RADIO RECEIVER (w/o Multi-display): Installation

INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (See INSTALLATION )

Fig 1: Locating No. 2 Radio Bracket Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLOCK ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 RADIO BRACKET
1. Install the bracket with the 3 bolts.
  Torque: 3.0 N.m (30 kgf*cm, 26 in.*lbf)
  
  Fig 2: Locating No. 1 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 RADIO BRACKET
1. Install the bracket with the 3 bolts.
  Torque: 3.0 N.m (30 kgf*cm, 26 in.*lbf)
INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
1. Connect the connectors.
  
  Fig 3: Locating No. 2 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the radio receiver to attach the 10 claws on its backside.
  NOTE: When inserting the radio receiver, do not press the knobs on it.
  
  Fig 4: Inserting Radio Receiver Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the radio receiver with the 2 screws and 2 bolts.
  Torque: for bolt
  
  12 N.m (122 kgf*cm, 8 in.*lbf)
INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 5: Identifying Radio Receiver Assembly Bracket Screws & Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002