Back Door Speaker: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE CENTER BACK DOOR GARNISH  (See DISASSEMBLY )
3. REMOVE BACK DOOR SIDE GARNISH LH  (See DISASSEMBLY )
4. REMOVE BACK DOOR SIDE GARNISH RH  (See DISASSEMBLY )
5. REMOVE BACK DOOR TRIM PANEL ASSEMBLY  (See DISASSEMBLY )
6. REMOVE REAR HEADER SPEAKER ASSEMBLY 
   1. Remove the 3 screws.
   2. Disconnect the connector and remove the speaker with bracket.
      Fig 1: Locating Speaker Bracket Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Detach the clamp.
   4. Remove the 2 screws and speaker from the bracket.
      Fig 2: Locating Speaker Bracket Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002