Inspection Procedure
- CHECK FOR DTC
- Check for DTCs (See DTC B1500 FUEL SENDER OPEN DETECTED
).
Result
RESULT CHARTResult Proceed to DTC B1500 is not output A DTC B1500 is output B
B: Go to DTC B1500 (See DTC B1500 )
A: Go to next step.
- Check for DTCs (See DTC B1500 FUEL SENDER OPEN DETECTED
).
- PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE ASSEMBLY)
- Operate the Techstream according to the display and select Active Test (See DATA LIST / ACTIVE TEST
).
Combination Meter
DIAGNOSTIC NOTE CHARTTester Display Test Part Control Range Diagnostic Note Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2 or FULL Perform the test with the vehicle stopped and engine idling. OK: Needle indication is normal.
NG: REPLACE COMBINATION METER ASSEMBLY (See REMOVAL )
OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )
- Operate the Techstream according to the display and select Active Test (See DATA LIST / ACTIVE TEST
).