LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Electrical >> Gauges >> Meter >> Meter / Gauge System >> Data List / Active Test

Data List / Active Test

  1. DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.
    5. According to the display on the Techstream, read the Data List.

      Combination Meter 

      DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW Trip switch (ODO/TRIP switch) condition/ON or OFF ON: Trip switch (ODO/TRIP switch) pushed
      OFF: Trip switch (ODO/TRIP switch) not pushed      		 -
      Tail Cancel SW TAIL cancel switch condition/ON or OFF ON: TAIL cancel switch ON
      OFF: TAIL cancel switch OFF      		 -
      Washer Switch Washer switch/ON or OFF ON: Washer switch ON
      OFF: Washer switch OFF      		 -
      P-Seatbelt Buckle SW Front passenger side seat belt warning light request signal/ON or OFF ON: Tongue plate (front passenger side) inserted
      OFF: Tongue plate (front passenger side) not inserted      		 -
      Oil Level SW Oil level switch/ON or OFF ON: Oil level switch ON
      OFF: Oil level switch OFF      		 -
      Multi Display Select Switch Steering multi-display select switch/ON or OFF ON: Steering multi-display select switch ON
      OFF: Steering multi-display select switch OFF      		 -
      Vehicle Speed Meter Vehicle speed/Min.: 0 (0), Max.: 255 (158) Almost same as actual vehicle speed (when driving) Unit: km/h (mph)
      Engine Rpm Engine speed/Min.: 0, Max.: 12750 rpm Idling: 700 to 800 Unit: rpm
      Coolant Temperature Engine coolant temperature/Min.: -40 (-40), Max.: 140 (284) F After warming up: 80 to 105 (176 to 221)
      • Unit: °C (°F).
      • If the value is -40 (-40): The sensor circuit is open.
      • If the value is 140 (284): The sensor circuit is shorted.
      Fuel Input Fuel sender gauge input/Min.: 0, Max.: 127.5 L Fuel sender input value Unit: L
      Rheostat value Light control rheostat switch input/Min.: 0, Max.: 100 Light control rheostat switch is fully turned right (0) → fully turned left (100) Unit: %
      Communication ECM/Meter DTC 3 ECM communication stop history/Rec or Unrec Rec: DTC is stored
      Unrec: DTC is not stored      		 -
      ECM ODO (History 3) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999 Without history: ffffffh -
      Communication ECM/Meter DTC 2 ECM communication stop history/ Rec or Unrec Rec: DTC is stored Unrec: DTC is not stored -
      ECM ODO (History 2) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999 Without history: ffffffh -
      Communication ECM/Meter DTC 1 ECM communication stop history/ Rec or Unrec Rec: DTC is stored
      Unrec: DTC is not stored      		 -
      ECM ODO (History 1) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999 Without history: ffffffh -
      Communication ABS/Meter DTC 3 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is stored
      Unrec: DTC is not stored      		 -
      ABS/VSC ODO (History 3) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
      Without history: ffffffh      		 -
      Communication ABS/Meter DTC 2 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is stored
      Unrec: DTC is not stored      		 -
      ABS/VSC ODO (History 2) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
      Without history: ffffffh      		 -
      Communication ABS/Meter DTC 1 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is stored
      Unrec: DTC is not stored      		 -
      ABS/VSC ODO (History 1) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
      Without history: ffffffh      		 -
      Units By Region Units of display setting / Km/l JP, Km/l, Ml/g US or Ml/g UK Displays units setting -
      Language Language of display setting/ English, Spanish, French*, German* or Italian* Displays language setting -
      Driver Side Seatbelt Warning Buzzer Front driver side seat belt warning buzzer setting/ON or OFF ON: Front driver side seat belt warning buzzer ON setting
      OFF: Front driver side seat belt warning buzzer OFF setting      		 -
      P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer setting/ON or OFF ON: Front passenger side seat belt warning buzzer ON setting
      OFF: Front passenger side seat belt warning buzzer OFF setting      		 -
      +B Voltage Value +B voltage/Min.: 0, Max.: 25.5 Below 1 to 14 V Unit: V

      Engine 

      DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Engine Rpm Engine speed/Min.: 0, Max.: 16383.75 Idling: 700 to 800 rpm Unit: rpm
      Vehicle Speed Meter Vehicle speed/Min.: 0 (0), Max.: 255(158) Actual vehicle speed
      • Unit: km/h (mph)
      • The speed is indicated on the speedometer.
      Coolant Temp Engine coolant temperature/ Min.: -40 (-40), Max.: 140 (284) F 80 to 100 (176 to 221 °F): After warming up If the value is -40 (-40°F): the sensor circuit is open.
      If the value is 140 (284°F): the sensor circuit is shorted.
  2. ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / (Combination Meter) / Active Test.
    5. According to the display on the Techstream, perform the Active Test.

      Combination Meter 

      ACTIVE TEST

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation*1 Speedometer 0, 40, 80,120,160, 200, 240 or 280 Perform the test with the vehicle stopped and engine idling.
      Tachometer operation Tachometer 0,1000, 2000, 3000, 4000, 5000, 6000 or 7000 Perform the test with the vehicle stopped and engine idling.
      Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL Perform the test with the vehicle stopped and engine idling.
      Volt Meter Operation Voltmeter 0,3, 6, 9,12, 15 or 18 Perform the test with the vehicle stopped and engine idling.
      Oil Pressure Meter Operation Oil pressure receiver gauge LOW, 1/4, 1/2, 3/4 or HIGH Perform the test with the vehicle stopped and engine idling.
      A/T Indicator operation (1) A/T indicator (normal mode) P, R, N, D, 4, 3, 2, L Perform the test with the vehicle stopped and engine idling.
      A/T Indicator operation (2) A/T indicator (sequential mode) Es, 5 or 6 Perform the test with the vehicle stopped and engine idling.
      Meter Display 1*2 All dots in the multi-information display ALL, 0,1,2, 3,4, 5 or 6 Perform the test with the vehicle stopped and engine idling.
      Meter Display 2*2 All dots in the multi-information display 7, 8 or 9 Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Beam BEAM indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Head HEAD indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Tail TAIL indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Fr FOG Fr. FOG indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Airbag SRS warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Precrash PCS indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Driver Side Seat Belt Driver side seat belt warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Front Passenger Side Seat Belt Passenger side seat belt warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Doors All Open All doors open light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Washer Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Fuel Low fuel warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Charge CHARGE warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp ABS ABS warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Slip SLIP indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Tire Pressure Warning System TIRE PRESSURE indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Brake Brake warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp oil Level Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp ECT PWR ECT PWR indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp Cruise CRUISE main indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. KEY Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Master Warning Master warning light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Clearance Sonar LCD Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. INTUITIVE P/A LCD Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Lamp VSC OFF Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. 2nd START 2nd START indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. Ctr DIFF LOCK Center differential lock indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. 4LO 4LO indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. CRAWL CRAWL indicator light ON or OFF Perform the test with the vehicle stopped and engine idling.
      Indicat. A/T P Multi-information display ON or OFF Perform the test with the vehicle stopped and engine idling.
      Water Temperature Meter Operation Engine coolant temperature receiver gauge LOW, NORMAL or HIGH Perform the test with the vehicle stopped and engine idling.
      HINT:
      *1:
      • The doors will be locked automatically when performing the speedometer Active Test. This is a normal function.
      • The displayed value has the same units (km/h, mph) as the main scale of the vehicle speedometer.
      • The needle position should be within the acceptable range.

      *2: If this Active Test is being performed and the engine switch is turned off and then on (IG), the A/T and ODO/TRIP display background may turn white. If this occurs, end this Active Test and turn the engine switch off.

      Main Body 

      DIAGNOSTIC NOTE CHART

      Tester Display Test Part Control Range Diagnostic Note
      Dimmer Signal Illumination dimming operation ON or OFF -
scientia non olet · About LEMON Manuals