Steering Wheel: Installation

POSITION FRONT WHEELS STRAIGHT AHEAD
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY
1. Align the matchmarks on the steering wheel assembly and steering main shaft.
2. Install the steering wheel assembly set nut.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
3. Connect the connectors to the spiral cable sub-assembly.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT STEERING PAD (See INSTALLATION )
INSPECT SRS WARNING LIGHT
HINT:

See DIAGNOSIS SYSTEM .

Fig 1: Identifying Matchmarks On Steering Wheel Assembly And Steering Main Shaft
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002