Drive Belt: Installation

1. Install the V-ribbed belt.
   Fig 1: Turning V-Ribbed Belt Tensioner Assembly Counterclockwise Using SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, turn the V-ribbed belt tensioner assembly counterclockwise and remove the bar.

   SST 09961-00950 

3. If it is difficult to install the V-ribbed belt, perform the following procedure:
   Fig 2: V-Ribbed Belt Routing

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Put the V-ribbed belt on every pulley except the tensioner pulley as shown below.
   2. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and put the V-ribbed belt on the V-ribbed tensioner assembly pulley.
      NOTE:

      • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.
      • Check that the V-ribbed belt is properly set to each pulley.
   3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crankshaft pulley by hand.

1. Clean the vehicle body surface.
   1. Using a heat light, heat the vehicle body surface.
   2. Remove the front fender side protector from the vehicle body.
   3. Wipe off any tape adhesive residue with cleaner.
2. Clean the front fender molding sub-assembly RH. (If reusing the front fender molding sub-assembly RH)
   Fig 3: Identifying Front Fender Side Protector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Using a heat light, heat the front fender molding sub-assembly RH.
   2. Remove the front fender side protector from the front fender molding sub-assembly RH.
   3. Wipe off any tape adhesive residue with cleaner.
   4. Install a new front fender side protector to the front fender molding sub-assembly RH.
3. Install the front fender molding sub-assembly RH.
   Fig 4: Identifying Front Fender Side Protector Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Using a heat light, heat the vehicle body and the front fender molding sub-assembly.
   2. Remove the release paper from the front fender molding sub-assembly.

      HINT:

      After removing the release paper, keep the exposed adhesive free from foreign matter.

   3. Engage the 3 clips and install the front fender molding sub-assembly RH.
4. Using a 4 mm hexagon wrench, install the screw.
   Fig 5: Identifying Front Fender Molding Screws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the clip.

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

Fig 6: Identifying Front Fender Molding Screws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002