Inspection Procedure

1. Check the Data List for proper functioning of the power back door touch sensor.

   Back door (Power back door ECU) 

   DIAGNOSTIC NOTE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   PBD Touch Sen L	Power back door touch sensor LH signal / ON or OFF	ON Power back door touch sensor LH is pressed OFF Power back door touch sensor LH is not pressed	-
   PBD Touch Sen R	Power back door touch sensor RH signal/ON or OFF	ON Power back door touch sensor RH is pressed OFF Power back door touch sensor RH is not pressed	-

   OK: The display is as specified in the normal condition. 

NG: Go to step   2 

OK: REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)  (See INITIALIZATION  )

1. Remove the power back door touch sensor. (See REMOVAL  )
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION TABLE
   
   

   Tester Connection	Condition	Specified Condition
   1 - 2	Not pressed	Approx. 1 kΩ
   1 - 2	Pressed	Below 100 Ω

   Fig 1: Identifying Power Back Door Touch Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE POWER BACK DOOR TOUCH SENSOR  (See REMOVAL  )

OK: Go to next step 

1. LH Side
   1. Disconnect the T7 sensor connectors.
   2. Disconnect the O15 ECU connector.
   3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION TABLE
      
      

      Tester Connection	Condition	Specified Condition
      T7-1 (OSL) - O15-15 (OSL)	Always	Below 1 Ω
      T7-2 (OSLE) - O15-14 (OSE)	Always	Below 1 Ω
      T7-1 (OSL) - Body ground	Always	10 kΩ or higher
      T7-2 (OSLE) - Body ground	Always	Below 1 Ω

      Fig 2: Identifying Harness & Connector (Power Back Door Touch Sensor - Power Back Door Drive Unit & Body Ground) (1 Of 2)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. RH Side
   1. Disconnect the T8 sensor connectors.
   2. Disconnect the O15 ECU connector.
   3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION TABLE
      
      

      Tester Connection	Condition	Specified Condition
      T8-1 (OSR) - O15-13 (OSR)	Always	Below 1 Ω
      T8-2 (OSRE) - O15-14 (OSE)	Always	Below 1 Ω
      T8-1 (OSR) - Body ground	Always	10 kΩ or higher
      T8-2 (OSRE) - Body ground	Always	Below 1 Ω

      Fig 3: Identifying Harness & Connector (Power Back Door Touch Sensor - Power Back Door Drive Unit & Body Ground) (2 Of 2)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)  (See INITIALIZATION  )