Inspection Procedure

1. Check if there are any foreign objects interfering with the back door operation.

   OK: There are no foreign objects. 

NG: REMOVE FOREIGN OBJECT 

OK: Go to next step 

1. Check the back door operation.
   1. Turn the door control main switch off.
   2. Open / close the back door by hand.

      OK: The back door fully opens and closes smoothly. 

NG: ADJUST BACK DOOR 

OK: Go to next step 

1. Check the Data List to determine if the power back door touch sensor functions properly.

   Back door (Power back door ECU) 

   DIAGNOSTIC NOTE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   PBD Touch Sen L	Power back door touch sensor LH signal / ON or OFF	ON Power back door touch sensor LH pressed OFF Power back door touch sensor LH not pressed	-
   PBD Touch Sen R	Power back door touch sensor RH signal/ON or OFF	ON Power back door touch sensor RH pressed OFF Power back door touch sensor RH not pressed	-

   OK: The power back door sensors function as specified in the normal condition. 

NG: GO TO OTHER FLOW TABLE  (See TOUCH SENSOR CIRCUIT  )

OK: REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)  (See REMOVAL  )