LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Except Hybrid) >> Rear No. 1 Seat Outer Belt Assembly >> Installation

Rear No. 1 Seat Outer Belt Assembly: Installation

  1. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY 
    1. Install the rear No. 1 seat outer belt assembly with the 2 bolts.

      Torque: Bolt < A > 

      7.5 N*m (77 kgf*cm, 66 in.*lbf) 

      Bolt < B > 

      42 N*m (428 kgf*cm, 31 ft.*lbf) 

      Fig 1: Identifying Rear No. 1 Seat Outer Belt Assembly Bolts
      G05419462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the shoulder anchor of the rear No. 1 seat outer belt assembly with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      Fig 2: Identifying Shoulder Anchor Of Rear No. 1 Seat Outer Belt Assembly With Bolt
      G05419460Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Check if the ELR locks.
      NOTE: The check should be performed with outer belt assembly installed.
      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
  2. INSTALL QUARTER PILLAR GARNISH  (See INSTALLATION )
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)  (See INSTALLATION )
  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)  (See INSTALLATION )
  5. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY 
    1. Connect the floor anchor end of the rear No. 1 seat outer belt assembly and install the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear No. 1 seat outer belt assembly to overlap the protruding part of the floor panel.
      Fig 3: Identifying Rear No. 1 Seat Outer Belt Assembly With Bolt
      G05419464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FRONT DECK SIDE TRIM COVER  (See INSTALLATION )
  7. INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side)  (See INSTALLATION )
  8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)  (See INSTALLATION )
  9. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
  10. INSTALL REAR DECK TRIM COVER (for LH Side without Remote Folding Function)  (See INSTALLATION )
  11. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH (for LH Side with Remote Folding Function)  (See INSTALLATION )
  12. INSTALL REAR POWER OUTLET SOCKET COVER (for LH Side)  (See INSTALLATION )
  13. INSTALL REAR POWER POINT SOCKET ASSEMBLY (for LH Side)  (See INSTALLATION )
  14. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH (for LH Side)  (See INSTALLATION )
  15. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (for RH Side)  (See INSTALLATION )
  16. INSTALL SIDE TRIM COVER RH (for RH Side without Rear Automatic Air Conditioning System)  (See INSTALLATION )
  17. INSTALL REAR ROOM TEMPERATURE SENSOR (for RH Side with Rear Automatic Air Conditioning System)  (See INSTALLATION )
  18. INSTALL SIDE TRIM COVER LH (for LH Side without Rear Seat Entertainment System)  (See INSTALLATION )
  19. INSTALL POWER OUTLET SOCKET BEZEL (for LH Side with Rear Seat Entertainment System)  (See INSTALLATION )
  20. INSTALL DECK SIDE TRIM  (See INSTALLATION )
  21. INSTALL DECK SIDE TRIM COVER  (See INSTALLATION )
  22. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side without Rear Air Conditioning System)  (See INSTALLATION )
  23. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side with Rear Air Conditioning System)  (See INSTALLATION )
  24. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
  25. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)  (See INSTALLATION )
  26. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat)  (See INSTALLATION  )
  27. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) 
  28. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat)  (See REMOVAL  )
  29. INSTALL REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)  (See INSTALLATION )
  30. INSTALL DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat)  (See INSTALLATION )
  31. INSTALL REAR MAT  (See INSTALLATION )
  32. INSTALL DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat)  (See INSTALLATION )
  33. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
  34. INSTALL REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  35. INSTALL REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat)  (See INSTALLATION )
  36. INSTALL DECK SIDE TRIM BOX RH  (See INSTALLATION )
  37. INSTALL JACK CARRIER ASSEMBLY  (See INSTALLATION )
  38. INSTALL JACK ASSEMBLY  (See INSTALLATION )
  39. INSTALL JACK CARRIER CUSHION  (See INSTALLATION )
  40. INSTALL JACK CARRIER SUPPORT 
  41. INSTALL REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  42. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 
  43. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  44. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  45. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
  46. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
  47. INSTALL REAR DOOR SCUFF PLATE  (See INSTALLATION )
  48. INSTALL REAR NO. 1 SEAT ASSEMBLY  (See INSTALLATION )
  49. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY (w/ Remote Folding Function)  (See INSTALLATION )
  50. INSPECT REAR SEAT SLIDE ADJUSTER LOCK  (See INSTALLATION )
  51. INSTALL REAR SEAT LEG SIDE COVER  (See INSTALLATION )
  52. INSTALL REAR INNER TRACK BRACKET COVER  (See INSTALLATION )
  53. INSTALL REAR OUTER TRACK BRACKET COVER  (See INSTALLATION )
  54. INSTALL REAR SEAT TRACK BRACKET COVER  (See INSTALLATION )
  55. INSTALL REAR SEAT HEADREST ASSEMBLY  (See INSTALLATION )
  56. INSTALL REAR CENTER SEAT ASSEMBLY (for LH Side) 
scientia non olet · About LEMON Manuals