LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Except Hybrid) >> Rear No. 2 Seat Inner Belt Assembly >> Removal

Rear No. 2 Seat Inner Belt Assembly: Removal

  1. REMOVE DECK BOARD ASSEMBLY  (See REMOVAL )
  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)  (See REMOVAL )
  5. REMOVE REAR SEAT SIDE COVER LH  (See REMOVAL )
  6. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  7. REMOVE REAR SEAT SIDE COVER RH  (See REMOVAL )
  8. REMOVE JACK CARRIER SUPPORT 
  9. REMOVE JACK CARRIER CUSHION  (See REMOVAL )
  10. REMOVE JACK ASSEMBLY  (See REMOVAL )
  11. REMOVE JACK CARRIER ASSEMBLY  (See REMOVAL )
  12. REMOVE DECK SIDE TRIM BOX RH  (See REMOVAL )
  13. REMOVE REAR MAT  (See REMOVAL )
  14. REMOVE DECK FLOOR BOARD ASSEMBLY  (See REMOVAL )
  15. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY 
    1. Remove the bolt and rear No. 2 seat inner belt assembly.

      HINT:

      Use the same procedure for the RH side and LH side.

      Fig 1: Identifying Rear No. 2 Seat Inner Belt Assembly With Bolt
      G05419449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals