LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Supplemental Restraint System) >> Spiral Cable >> Removal

Spiral Cable: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing (see PRECAUTION  ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE STEERING PAD ASSEMBLY (See  REMOVAL   ) 
  3. REMOVE STEERING WHEEL ASSEMBLY 
  4. REMOVE FRONT DOOR SCUFF PLATE LH 
  5. REMOVE COWL SIDE TRIM BOARD LH 
  6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 
  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See  REMOVAL  ) 
  8. REMOVE NO. 1 LOWER PANEL (See  REMOVAL  ) 
  9. REMOVE STEERING COLUMN COVER (See  REMOVAL  ) 
  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY 
    1. Disconnect the connectors from the spiral cable.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
    2. Remove the 4 screws and spiral cable.
scientia non olet · About LEMON Manuals