Rear Axle Shaft: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included (see REASSEMBLY ).
After installation, fill the brake reservoir with brake fluid, bleed the brake system (see BLEEDING ), check for leaks and check the ABS speed sensor signal (see OPERATION CHECK ).

INSTALL REAR AXLE SHAFT OIL SEAL
1. Using SST and a hammer, tap in a new oil seal.
  SST 09950-60020 (09951-00710), 09950-70010 (09951-07150)
2. Coat MP grease to the oil seal lip.
  
  Fig 1: Installing Rear Axle Shaft Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002