Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

RECONFIRM DTC

Clear the DTC(s) (See DTC CHECK / CLEAR ).
Start the engine.
Drive the vehicle at 4 mph (6 km/h) or more to activate the initial check.

Check if the same DTC(s) is output (See DTC CHECK / CLEAR ).

Result

RESULT CHART

Result	Proceed to
DTC output	A
DTC not output	B

HINT:

The DTCs may be stored due to a malfunction in the connector terminal.

B: END

A: REPLACE BRAKE ACTUATOR (See REMOVAL )