LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Tire And Wheel) >> TIRE PRESSURE WARNING RECEIVER (for Sedan) >> Removal

TIRE PRESSURE WARNING RECEIVER (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE REAR SEATBACK ASSEMBLY RH (for 60/40 Split Seat Type)  (See REMOVAL )
  3. REMOVE REAR SEATBACK ASSEMBLY LH (for 60/40 Split Seat Type)  (See REMOVAL )
  4. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)  (See REMOVAL )
  5. REMOVE REAR DOOR SCUFF PLATE RH  (See REMOVAL )
  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See REMOVAL )
  7. REMOVE REAR SEAT SIDE COVER RH  (See REMOVAL )
  8. REMOVE ROOF SIDE INNER GARNISH RH  (See REMOVAL )
  9. REMOVE TIRE PRESSURE WARNING RECEIVER ASSEMBLY (w/ Antenna) 
    1. Disconnect the tire pressure warning receiver connector.
      2. Fig 1: Identifying Tire Pressure Warning Receiver Assembly Bolts With Clip
      G05591503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt.
    3. Disengage the clip and remove the tire pressure warning receiver.
scientia non olet · About LEMON Manuals